| 1. |
Open the battery door, then install 9V battery and insert battery door properly. |
| 2. |
Turn on & calibration: Place detector firmly against surface, press and release ON/MODE button, LCD will display all indicators. When auto-calibration finished will remain in display. |
| 3. |
Locating center of stud: Slide unit across wall, addition bars will appear when a stud edge is approached. Continue moving unit until center bar indicator disappears and unit no longer beeps. Center is between ON and OFF of display indicators and beeping. |
| 4. |
Metal detection: Metal indicator turns on then bars begin to close center bar and beeping indicate metal edge. |
| 5. |
Live wire detection: When the detector approaches AC wire, LCD will blink AC wire in indicator. |
| 6. |
Switch off: Auto shut-off in 150 seconds or press ON/MODE button in 3 seconds to turn off. |
