Features:
- 250 MHz IBM PowerPC Processor (350 Mips)
- Linux Operating System
- 1 Card Reader
- MPEG2 Hardware decoding
- DVB-S
- V.24/RS232 Interface
- 100Mbit Ethernet interface Two-way
- 2 LED instructions
- An infinite number of TV / radio channel list
- Channel switching time is less than 1 second
- Automatic service scan
- EPG (Electronic Program Guide)
- Support for DiSEqC
- Multi-language
- Digital bit stream output SPDI / F Interface (AC-3 / DTS)
- 1 x Scart-European plug (software control)
Technical parameters:
IF Input :950-2150 MHz
Signal Level - 65 dBm .... - 25 dBm
SNR 12 dB maximum.
Female F socket
Input Impedance 75 Ohm
AFC + / - 3 MHz
QPSK
Enter symbol rate range of 2 .... 45 M, SCPC / MCPC
Error correction 1 / 2, 2 / 3, 3 / 4, 5 / 6, 7 / 8, automatic
Video Decoder:
MPEG-2 and MPEG-1 compatible
PAL G / 25 Hz standard
Video Aspect Ratio 4:3 / 16:9 (automatic)
Audio Decoder:
MPEG-1 & MPEG-2 Layer I / II
Stereo
Frequency: 32 kHz, 44.1 kHz, 48 kHz, 16 kHz, 22.05 kHz, 24 kH
Analog Output:
Output Level L / R 0,5 Vss 600 Ohm
THD> 60 dB (1 kHz)
Isolation <-65 dB
Digital Output:
Output Level 0,5 Vss 75 Ohm
Sampling digital filter 32 kHz, 44.1 kHz, 48 kHz
S/PDIF- optical output (AC3)
Video parameters:
Enter FBAS 1 Vss + / - 0.3 dB on 75 Ohm
Teletext Filter: ETS 300 472 Standard
Scart plug Europe:
Output: FBAS, RGB, S-VHS
RS 232 interface:
Bit rate 115,2 kBit / s maximum.
Plug SUB-D-9
Firmware Upgrade
Ethernet port:
Ethernet port Firmware Upgrade
LNB Power and Polarity:
LNB Current 500mA maximum. Short-Circuit Protection
Vertical polarization LNB Voltage <14V without load,> 11.5V (400mA)
Horizontal polarization LNB Voltage <20V without load,> 17,3 V (400mA)
LNB power-down standby
Receiver control:
DiSEqC 1.0/1.2 SAT Location / SAT Select
DiSEqC - Motor Control
Power consumption: <10W / 12V
Input Voltage:
DC12V, AC + / - 15%
External power supply:
Input :110-240V AC / 50-60Hz / 0,6 A
Output: 12V = / 1A
Physical Specifications:
Temperature of +15 ° C. .. +35 ° C
Humidity, "80%
